Category Archives: 3D Printing

3D Printed Lever for AirPax Circuit Breakers

Posted on June 9, 2015 by Tom

This is a very specific project, but I’m writing about it anyway in case someone has the same problem. I own an old boat, with an old switch panel that has old circuit breakers. Needless to say these particular breakers are … Continue reading →

Posted in 3D Printing, Sailing | Tagged , , , | Leave a comment

Robot Prototyping 101

Posted on November 10, 2013 by Tom

Over the past few years, the back of my mind has been thinking about a small, quick, camera robot I could drive around. Recently, with the help of a 3D printer I was finally able to print a chassis and … Continue reading →

Posted in 3D Printing, Robots | Tagged , , , | Leave a comment

3D Printed Phone Holder

Posted on October 30, 2013 by Tom

I decided to try my hand at designing and 3D printing a phone holder using Solidworks. Two prongs on the back allow me to attach it to a car’s AC vent, and the thread on one side allows it to … Continue reading →

Posted in 3D Printing | Tagged , , , , , | 1 Comment